Parallel arrangement of the motor and rope drum
Thanks to parallel-shaft helical gear units with a larger center distance
Savings in terms of costs and weight
The helical gear units with a larger center distance mean it is no longer necessary to oversize the gear units from reasons of space
Light and low in vibrations
Due to the gray cast iron housing that has been optimized in terms of weight and rigidity
Always perfectly suited to the application
Thanks to finely stepped torque classes from 12.8 to 112 kNm and a gear ratio range from 14 to 250
The hoist gear unit is available as a catalog product and a special calculation program is used for the configuration
Can be combined flexibly
Thanks to a range of options that ensure optimum adjustment to the installation situation
Hoists often feature parallel-shaft gear units in which the rope drum and motor are arranged on the same side of the gear unit. Compact universal drives therefore often have to be oversized in terms of the torque, as the center distance between the input and output shafts is insufficient.
The new industrial gear unit series X..e/HC originates from the established X series from SEW-EURODRIVE and has an larger center distance.
This gives the crane designer crucial advantages when designing the system:
Reducing the total mass to be moved in this way, means that additional savings in terms of energy consumption can also be made. To increase this effect still further, the travel drives can also be made smaller if required.
Not only optimal installation, but also optimal use and maintenance. Here, too, the X..e/HC application series with its options is uncomplicated in use and easy to maintain.
To absorb the radial loads from the wire rope tension, the gear unit is equipped with a reinforced solid shaft and reinforced bearings as standard. Depending on the system design, the drives are also available with hollow shafts for connecting to the application. In addition, foot-mounted design and torque arm variants are available to support the torque.
Special calculation programs enable configuration for a defined service life, e.g. with FEM-typical load spectra and crane ratings. Additional customer specifications in terms of safety values and application factors can also be included in the calculation.
Your standardized solution for hoisting applications: With our X..e/HC series, you can optimally cover the torque range from 12.8 to 112 kNm as needed. A wide range of equipment options, including motor adapters, brake consoles, couplings, brakes and (brake)motors, expand the product into a complete drive solution.
Gear unit design
Nominal torque MN2
Helical gear unit X..e/HC
3 to 4 stages
14 – 250
12.8 – 112